Module 11: Fabrication and Competition Readiness
The last module closes the loop from design to competition: holding tolerances, printing parts that fit, passing inspection, and keeping the robot running through a long tournament day.
5Lessons
0Completed
Not StartedCurrent Status
Lesson Roadmap
11.1 · Tolerances & FitsLesson 11.1: Tolerances, Clearance Fits, and Press FitsOpen11.2 · Printed PartsLesson 11.2: Designing 3D Printed Parts That Survive FTC LoadsOpen11.3 · InspectionLesson 11.3: Passing Robot Inspection on the First AttemptOpen11.4 · Match DayLesson 11.4: Pit Organization and Match Day MaintenanceOpenModule 11 · Mastery QuizModule 11 Mastery Quiz: Fabrication and Competition ReadinessOpen
What This Unit Covers
Choose a fit class for a shaft and hole and understand what tolerance the fit demands.
Design printed parts that survive robot loads and fit their mating hardware.
Walk the robot through the inspection checklist before an inspector does.
Run a pit that can diagnose and repair the robot between matches.
Review the sequence and goals here, then resume at your first incomplete lesson.
Need to move faster?
Mark every lesson in Module 11 complete, save it on this device, and jump straight to Module 12: Shop Standards and Non-Negotiables.
Stuck on this lesson?
Ask about anything on this page. It can see which lesson you have open and which part you are reading.